Код ошибки

Неисправность

Возможные причины

E 01

Malfunction in the cutter section: The cutter does not reach both right and left cutter position switches within 2 seconds

1) Drive wire cut

2) Drive section malfunction

3) No power supply

E 02

Malfunction in the paper table drive section: The lower limit sensor or the paper table height sensor status does not change even though the paper table Up or Down signal is applied

1) Drive worm gear broken

2) Mounting screw of the worm gear broken



3) No power supply

E 04

The temperature of the thermal head or the power supply unit is high: The temperature of the thermal head becomes greater than 53°C

1) Defective thermistor

2) Defective thermal head

3) Defective power supply unit

E 05

Malfunction in the image shifting section: All the encoder output signals are at the "H" level

1) Encoder connector of the image shifting section is disconnected

2) Defective encoder

E 06

Mechanical lock: The drum rotation sensor detects that the drum rotation speed is abnormal

1) Mechanical lock

2) Main motor failure

E 09

Malfunction of the thermal head

1) Defective thermal head

2) Defective thermistor

3) Thermal head harness broken

E 10

Malfunction in the thermal head drive section

1) Defective main control PCB

2) Thermal head drive wire short circuit

E 11

Image shift motor malfunction: The encoder status does not change within 3 seconds after the encoder motor starts rotating

1) Image shift motor lock

2) Image shift motor harness broken

E 12

Malfunction in the pressure plate drive section: The loner pressure plate sensor is not actuated within 8 seconds. The upper pressure plate sensor is not actuated within 4 seconds

1) Pressure plate motor lock

2) Pressure plate motor harness broken

3) Pressure plate position sensor malfunction