F.A.Q. по ремонту и обслуживанию копиров


Konica 1120


Код ошибки

Описание

04

PTC heater. Don't know what this is, but "0" means it is not installed. 1 means it is.

F09

Power leakage of some kind. Heat, exposure, AC or power supply or main relay. Go to "25 mode" and select "P49" and reset to "0"

F23

Toner motor

F26

Toner density adjustment problem. This means the machine is undertoned. To repair, replace developer and enter "47" mode. Press 51. Press print. Allow the machine to cycle until it stops. Some feel you should disconnect the toner motor first. This Код ошибки happens probably because either the machine wasn't set up properly, or because the customer kept using the machine with the light on.

F28

Corona problem. Could be any corona.

F34

High fuser temperature.

F35, F36

Low fuser temperature.

F41, F42

Scan home

F43

Exposure lamp or exp. Lamp board.

F44

Lens drive problem.

F45

Lens problem.

F54

Fan motor.

F60

ADF to main board communication problem.

F67

ADF enКод ошибкиr (pulse sensor, drive problem)

F70

Sorter to machine communication problem.

F77

Sorter gate.

F88

AE adjustment problem.

J11-J13

Feed jam

J14-J16

Jam inside

J31, J32

Exit jam

J61, J62

ADF jam

J63

ADF exit jam

J72

Sorter jam

P11

Count. For total count, select "0". For developer count, select "5".

P12

Preheat mode fuser temperature. 0 for 365 degrees. 1 for 374 degrees. 2 for 383 degrees.

P15

Size priority. 0 is standard. 1 is a size priority.

P16

Paper size priority.

P19

Preheat shut off timing. 0 for 1 hour. 1 for 2 hours. 2 for 3 hours.

P20

Drum unit or toner level connection problem. Most likely, a loose connection.

P22-P24

Kind of obscure. This sets the wait time for tuning intermittent test copies in a 36 mode test.

P25

300 copies have been run since toner light came on, depending on how 25 mode, Код ошибки 92 is set, machine may not work at all.

P26

ADF border erase. 0 for none. 5 for 5mm.

P26

Must replace and calibrate developer.

P27

PM cycle. 27 is for the 5th digit. 28 is for the fourth digit.

P27

Toner density sensor unplugged or toner density sensor problem.

P28

PM cycle. 27 is for the 5th digit. 28 is for the fourth digit.

P64

ADF & operator are confused. Remove original.

P68, P69

ADF feed problem.

P71

Sorter interlock.

P81

Key counter not installed.




- Начало -  - Назад -  - Вперед -